EasyManuals Logo

Denon AVR-X6700H User Manual

Denon AVR-X6700H
351 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #318 background imageLoading...
Page #318 background image
Resetting network settings
If network contents cannot be played or the unit cannot connect to the network, restarting the unit may improve the problem. We recommend restarting the
unit before returning the settings to the default settings. (v p. 296)
If the operations are not improved by restarting the unit, follow the steps below.
Network settings are reset to the factory default values. Make settings again.
However, the menu “Amp Assign”, “Speaker Config.” and “Video” settings are not reset.
.
SOURCE SELECT
p
DIMMER
X
1
Press X to turn on power to the unit.
2
Turn SOURCE SELECT to select “HEOS Music”.
3
Press and hold the main unit's DIMMER and p at the
same time for at least 3 seconds.
4
Remove your fingers from the two buttons when
“Network Reset...” appears on the display.
5
“Completed” is shown in the display when reset is
complete.
0
Before returning the settings to the default settings, use the “Save & Load” function
from the menu to save and restore the details of various settings configured on the
unit. (v p. 283)
0
You can also reset the network settings to the factory defaults using “Reset” -
“Network Settings” in the menu. (v p. 284)
NOTE
0
Do not turn the power off until reset is complete.
Contents Connections Playback Settings Tips Appendix
318
Front panel Display Rear panel Remote Index

Table of Contents

Other manuals for Denon AVR-X6700H

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X6700H and is the answer not in the manual?

Denon AVR-X6700H Specifications

General IconGeneral
Channels11.2
Power Output140W per channel (8 ohms, 20Hz-20kHz, 0.05% THD)
Speaker Impedance4-16 ohms
Input Sensitivity/Impedance200mV / 47k ohms
HDMI Inputs8
HDMI Outputs3
HDCP SupportHDCP 2.3
HDR CompatibilityHDR10, HDR10+, Dolby Vision, HLG
Audio Return Channel (ARC)eARC
Video Upscaling8K
BluetoothYes
Wi-FiYes
EthernetYes
Voice Assistant SupportAmazon Alexa, Google Assistant, Apple Siri
Phono InputYes
Zone Audio Output3 Zones
Room CalibrationAudyssey MultEQ XT32
Frequency Response10Hz-100kHz (+1, -3 dB, Direct Mode)
Total Harmonic Distortion0.05%
Signal-to-Noise Ratio102dB
HDMI Support4K/120Hz, 8K/60Hz
USB Port1
Streaming ServicesAirPlay 2, HEOS, Spotify, Tidal, Deezer, Amazon Music, Pandora, SiriusXM
Audio DecodingDolby Atmos, DTS:X, Auro-3D

Related product manuals