EasyManuals Logo

Denon AVR-X6700H User Manual

Denon AVR-X6700H
351 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #235 background imageLoading...
Page #235 background image
Error messages
An error message is displayed if Audyssey
®
Setup could not be completed due to speaker placement, the measurement environment, etc. If an error
message is displayed, check the relevant items and perform the necessary measures. Be sure to turn off the power before checking speaker connections.
Examples Error details Measures
No speakers found.
0
Sound calibration microphone is not
detected.
0
Connect the included Sound calibration microphone to the
SETUP MIC jack of this unit.
0
Not all speakers could be detected.
0
Check the speaker connections.
Ambient noise is too high or level is too
low
0
There is too much noise in the room.
0
Either turn off any device generating noise or move it away.
0
Perform again when the surroundings are quieter.
0
Speaker or subwoofer sound is too low.
0
Check the speaker installation and the direction in which the
speakers are facing.
0
Adjust the subwoofer’s volume.
Front R : None
0
The displayed speaker could not be
detected.
0
Check the connections of the displayed speaker.
Front R : Phase
0
The displayed speaker is connected with the
polarity reversed.
0
Check the polarity of the displayed speaker.
0
For some speakers, this error message may be displayed
even if the speaker is properly connected. If you are sure the
connection is correct, press p to select “Ignore”, then press
ENTER.
Contents Connections Playback Settings Tips Appendix
235
Front panel Display Rear panel Remote Index

Table of Contents

Other manuals for Denon AVR-X6700H

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X6700H and is the answer not in the manual?

Denon AVR-X6700H Specifications

General IconGeneral
Channels11.2
Power Output140W per channel (8 ohms, 20Hz-20kHz, 0.05% THD)
Speaker Impedance4-16 ohms
Input Sensitivity/Impedance200mV / 47k ohms
HDMI Inputs8
HDMI Outputs3
HDCP SupportHDCP 2.3
HDR CompatibilityHDR10, HDR10+, Dolby Vision, HLG
Audio Return Channel (ARC)eARC
Video Upscaling8K
BluetoothYes
Wi-FiYes
EthernetYes
Voice Assistant SupportAmazon Alexa, Google Assistant, Apple Siri
Phono InputYes
Zone Audio Output3 Zones
Room CalibrationAudyssey MultEQ XT32
Frequency Response10Hz-100kHz (+1, -3 dB, Direct Mode)
Total Harmonic Distortion0.05%
Signal-to-Noise Ratio102dB
HDMI Support4K/120Hz, 8K/60Hz
USB Port1
Streaming ServicesAirPlay 2, HEOS, Spotify, Tidal, Deezer, Amazon Music, Pandora, SiriusXM
Audio DecodingDolby Atmos, DTS:X, Auro-3D

Related product manuals