0044-0391-0M Rev F y solo Series Owner’s Manual
15
KEYPAD FUNCTIONS
DO NOT operate the keypad with pointed objects (pencils, pens, etc.). Damage
to the keypad resulting from this practice is NOT covered under warranty.
This is the ON/OFF key. Press this key to apply power to the scale and turn it on.
If the scale is already on, pressing this key will turn the scale off.
This is the PRINT key. It is used to send weight and associated data to a
computer or other device connected to the USB port.
This is the ENTER key. It serves two purposes. First, when reviewing setup
parameters, pressing the key will accept the currently displayed setting of the
parameter. Second, the key is used to signal completion of the entry of data
(in both setup and operation) and causes the scale to process the data entered.
This is the ZERO key. It is used to reset the display to zero. Note that if the zero”
key is pressed with weight on the scale platform, the display will zero (tare) the
weight and change to .. When the weight is removed, the display will show a
negative weight value and then change to ..
To Next Page
Loading...
Need help?
General
