106
Browser for OpenCTI Configuring the PC Software
Installing the systray display
1. Call up the start mask of the sys-
tem CD (see Configuring the PC
Software on page 102).
2. From the start mask, select
“Software, install systray”. Fol-
low the program instructions.
3. Start the copied program by
“Start > Run” and the configura-
tion dialogue is displayed. Select
one of the entries displayed un-
der Existing PBXs. Enter your
user name and password in the
boxes under Log-on.
4. If you activate the Autostart
check box, you will see the
systray display even after re-
starting your PC.
5. Confirm the entries in the con-
figuration dialogue with OK and
the systray display logs on for
the OpenCom 100.
6. Right-click on the
systray display in
the Start bar. Select
Configuration to call up the
configuration dialogue. Select
Network Connections or Trunk
Lines to produce a status dia-
logue.
Browser for OpenCTI
You can simplify the daily use of the
OpenCTI using the Web browser es-
pecially adapted for the
OpenCom 100. Each time the work-
station is restarted, this browser pro-
gram can automatically start and log
you in. This means the OpenCTI is al-
ways operational and can be ac-
cessed using the icon in the informa-
tion area of the task bar.
Installing the browser for
OpenCTI
1. Call up the start mask from the
system CD (see Configuring the
PC Software on page 102).
2. From the start mask, select
“Software, Install browser for
OpenCTI”. Follow the program
instructions.
3. Follow the program instructions.
To Next Page
Loading...
