17
Installation Declarations of Conformity
The OpenCom 100 is designed for in-
door use only. Lay the cables so that
they cannot be walked on or tripped
over.
The connection of external devices
to the sensor/actor should be per-
formed by a qualified electrician.
Declarations of Conformity
The OpenCom 107, OpenCom 105,
OpenCom 110 and OpenCom 120
systems conform to the require-
ments set down in the EU directive
99/5/EC.
The Declaration of Conformity can
be viewed at the DeTeWe Web site at
http://www.detewe.de.
Mounting Location
The ambient temperature for oper-
ating the OpenCom 100 must be be-
tween +5 and +40°C. The power
supply must be 230 V/50 Hz AC. A
separate fuse for the power supply is
recommended.
To maintain the prescribed ambient
temperature, mount the
OpenCom 100 in a well-ventilated
location, away from direct sources of
heat.
Do not position the OpenCom 100
■ in front of or above heat sources
such as radiators,
■ in direct sunlight,
■ behind curtains,
■ in small, unventilated, damp
rooms,
■ on or near inflammable materi-
als,
■ or near high-frequency devices
such as transmitters, X-ray or
similar apparatus.
Use a separate 230 V power circuit
and install overvoltage protection.
To Next Page
Loading...
