109
Configuring the PC Software USB DECT Box on the OpenCom 100
The list of entries found should
now display the address from
the central telephone book.
Note: Only users can be found for
whom an internal telephone number
has been configured.
USB DECT Box on the OpenCom 100
General Information
The USB DECT Box provides a PC with
a wireless ISDN data connection
(DECT). The Box is connected to the
PC via the USB interface and uses the
RFP 21/23 to create a connection to
the OpenCom 100 and its network,
to the telephone network and to the
Internet.
Note: Up-to-date information on
the USB DECT Box can be found at
http://www.detewe.de/.
Installation and
Configuration
1. Connect the RFP 21/23 to a free
U
pn
interface on the
OpenCom 100. Instructions on
how to do this can be found in
the section Upn Ports starting on
page 24.
2. Configure the RFP 21/23 in the
Configurator, using the PBX
Configuration: Ports: U
pn
menu.
3. Install the software of the USB
DECT Box and then connect the
USB DECT Box to your PC. Fur-
ther information on this can be
found in the corresponding
chapter of the “USB DECT Box”
manual (which is included with
the USB DECT Box).
4. Create a new DECT device of the
type USB DECT Box in the Con-
figurator (menu PBX Configu-
ration: Ports: DECT-PP) and as-
sign a telephone number for the
data port.
5. Check the USB DECT Box in. Fur-
ther information on how to do
this can be found in the corre-
sponding chapter of the “USB
DECT Box” manual and in the
online help provided in the
OpenCom 100.
6. Assign a user to the telephone
numbers of the USB DECT Box in
the Configurator (menu User
Manager: User).
To Next Page
Loading...
