DETEWE opencom 105 - Saving and Loading the Configuration; Loading SW Updates

59
Configuration Configuring the OpenCom 100
Set IP address
H *182 Z (system PIN)
* Z (www) * Z (xxx) *
Z (yyy) * Z (zzz) #
Set NET mask
H *183 Z (system PIN)
* Z (www) * Z (xxx) *
Z (yyy) * Z (zzz) #
Restart
H * 1 8 5
Z (system PIN) #
Saving and Loading the
Configuration
Configurations are saved in a file ar-
chive and can be loaded to the
OpenCom 100 either locally from a
connected configuration PC, or by
remote configuration.
The following configuration and cus-
tomer data can be saved and loaded
again:
■ Telephony and network parame-
ters
■ User data
■ Telephone book entries
■ LCR tables
For further information, refer to the
online help documentation under
the topic SYS Configuration: Data
backup.
Loading SW Updates
New versions of the system and ter-
minal software can be loaded to the
system.
New software versions of the
OpenCom 100 are loaded from the
configuration PC, which accesses the
Configurator (see the SYS Configu-
ration: Firmware menu). For infor-
mation on connecting a configura-
tion PC, see Brief Guide to Initial
Configuration on page 46.
The terminal software is part of the
OpenCom 100 software and is auto-
matically loaded into the terminals
via the OpenCom 100 if the software
version in the terminal is different
from the terminal software stored in
the OpenCom 100.
Note: If you are operating an PBX
cascade, new system software is au-
tomatically transferred to the slave
system from the master system.
For further information, refer to the
online help documentation under
the item SYS Configuration:
Firmware.