47
Configuration System Requirements
4. Start the Web browser. Enter
“http://192.168.99.254/” in the
address box.
You will see the log-on page of the
Web console. Continue reading un-
der Configuring the OpenCom 100
starting on page 54.
System Requirements
Note: If no connection can be es-
tablished by following the instruc-
tions in the Brief Guide to Initial Con-
figuration starting on page 46, refer
to the more detailed explanations be-
low.
A normal TCP/IP-capable PC with a
Web browser is required for the ini-
tial configuration. The PC should at
least meet the following require-
ments:
■ IBM-compatible 200 MHz PC
■ 32 MB RAM and 50 MB of free
hard disk space
■ Microsoft Windows 95/98,
Microsoft Windows 2000/XP or
Microsoft Windows NT 4.0 oper-
ating system
■ Microsoft Internet Explorer ver-
sion 4.0 or higher, or Netscape
Communicator version 4.5 or
higher
Note: Microsoft Internet Explorer is
already installed in current versions
of the Microsoft Windows operating
system. If required, a Web browser
can be installed from the system CD
delivered with the OpenCom 100.
In addition, the selected type of con-
nection requires further system
components that you may have to
install on your PC. The driver soft-
ware is normally supplied with the
hardware, and the appropriate ver-
sion should be available for your op-
erating system. You will find the sys-
tem software on the installation CD
of your operating system.
For connection on the V.24 port
(COM port) you need:
■ Hardware: one free serial port
(RS-232, V.24) and a serial cable
(SUBD9). For configuration of
the OpenCom 105, use the
adapter cable supplied for con-
necting RS-232 to RJ-45.
■ System software: serial port
driver and TCP/IP protocol soft-
ware
■ Driver software: RAS adapter
software for installation on the
To Next Page
Loading...
