14
Internet Functions Factory Settings on Delivery
The following IP addresses are pre-
set for the network configuration:
■ Host name: host
■ IP address: 192.168.99.254
■ Network mask: 255.255.255.0
The following addresses are trans-
mitted to the client PCs in the LAN
via DHCP or PPP:
■ Gateway address:
192.168.99.254
■ Domain name: domain
■ Domain name server:
192.168.99.254
■ PPP addresses: 192.168.100.0 to
192.168.100.10
■ DHCP addresses: 192.168.99.129
to 192.168.99.148
You can change the IP settings in the
Configurator. Check with the net-
work administrator responsible for
the LAN if you wish to do this.
Information Regarding the
Licensing of the IP Package for
the OpenCom 100
In order to be able to use the IP
package in your communications
system, you need an activation key.
You can generate the activation key
on the DeTeWe licence server
(http://lizenz.detewe.de).
The activation key is generated on
the basis of the serial number of
your OpenCom 100 and the transac-
tion record (TAD). The licensing con-
firmation you received together with
your IP package contains all the in-
formation you need to carry out this
procedure plus your personal TAD.
To generate the activation key for
the IP package of the
OpenCom 105, no TAD is required.
The serial number is all you need.
You have therefore not received a
separate licence confirmation. Enter
the serial number of your
OpenCom 105 in the corresponding
field at http://lizenz.detewe.de.
You can read out the serial number
on the Web console of the
OpenCom 100 in the Configurator
in the System info: Versions menu.
Please note that the serial number is
case sensitive. Leave the field for the
TAD blank.
Note or print out the generated acti-
vation key.
Then release the IP package on the
Web console in the Configurator in
the SYS Configuration: Add-ons
menu. Additional information can
be found in the online help.
To Next Page
Loading...
