User Manual DEV 1953
118 Copyright DEV Systemtechnik GmbH 2015-2017
5.9.4.3.3 .application.simultaneousMode
OID: .1.3.6.1.4.1.21035.41.2.3.0
Syntax: INTEGER {simultaneous (1), individual (2)}
Access: read-write
Description: The switching mode (please refer to chapter 5.1.4), possible values:
"1" in Simultaneous switching mode all switch modules being
member of a group (defined by .swGroupMembers (chapter
5.9.4.3.5.2)) are switched synchronously if one member of
the group is switched via .swPosition (chapter 5.9.4.3.7.4) of
the .switchUnitTable
"2" in Individual switching mode all switch modules can be
switched independently
Note:
.simultaneousMode cannot be set to "1" if the switch modules within all groups
with two or more members are not in the same switch position (chapter 5.1.4).
5.9.4.3.4 .application.numberOfSwitchGroups
OID: .1.3.6.1.4.1.21035.41.2.4.0
Syntax: INTEGER32
Access: read-only
Description: The number of switch groups.
For this type of device "16" is returned.
Note:
For .numberOfSwitchUnits "16" is returned independently whether the device
is equipped with sixteen or less switch modules.
This value is used to determine the maximum index of the following table:
5.9.4.3.5 .application.switchGroupTable
"16" is returned for .numberOfSwitchGroups (please refer to chapter 5.9.4.3.4),
thus a corresponding number of entries per .switchGroupTable OID. The table is
used for the assignment of switch units (here: switch modules) to groups which is
required for simultaneous switching applications.
5.9.4.3.5.1 .application.switchGroupTable.switchGroupEntry.swGroupIndex
OID: .1.3.6.1.4.1.21035.41.2.5.1.1.x
Syntax: INTEGER32 (1..32)
Access: not-accessible
Description: A unique value for each table entry ranging between "1" and the
number of entries (defined by .numberOfSwitchGroups, please
refer to chapter 5.9.4.3.4).
To Next Page
Loading...
