DEV 1953 - Page 3

User Manual DEV 1953
 Copyright DEV Systemtechnik GmbH 2015-2017 3
3.3 Product Drawings--------------------------------------------------------------------- 27
3.3.1 Front Side DEV 1953 ----------------------------------------------------------------- 27
3.3.2 Rear Side DEV 1953 with 5 Modules (Demo Application) ------------------- 28
3.3.3 Rear Side DEV 1953 with 12 Modules (RF Switching Application) --------- 28
3.3.4 Rear Side DEV 1953 with 16 Modules (Digital Switching Application) ---- 29
4 Installation Instructions ------------------------------------------------ 29
4.1 Scope of Delivery --------------------------------------------------------------------- 29
4.2 Installation of the Product --------------------------------------------------------- 29
4.2.1 Mechanical Assembly ---------------------------------------------------------------- 29
4.2.2 Grounding, Data Cables, and Power Connection ------------------------------ 29
4.2.3 Connection of Optical Signal Cables ---------------------------------------------- 31
4.2.4 Connection of RF Signal Cables ---------------------------------------------------- 31
4.2.5 Installation and Exchange of Modules ------------------------------------------- 32
4.2.5.1 Exchange of the Micro-SD Card and Backup of the Configuration Data ----------- 33
4.2.6 Reset of the Device and the Restore of Factory Defaults ------------------- 33
4.3 Device Factory Settings ------------------------------------------------------------- 34
4.3.1 Factory Settings for Sensing Switch Modules ---------------------------------- 34
4.3.2 Factory Communication Protocol Configuration ------------------------------ 34
4.3.3 Factory Network Settings ----------------------------------------------------------- 34
4.3.4 Factory SNMP Settings --------------------------------------------------------------- 35
4.3.5 Factory Sandar Prosan Protocol Settings ---------------------------------------- 35
4.3.6 Factory Leitch Protocol Settings --------------------------------------------------- 35
4.3.7 Factory QEC Protocol Settings ----------------------------------------------------- 35
4.4 Communication Interface Configuration --------------------------------------- 35
4.4.1 Serial Interface------------------------------------------------------------------------- 35
4.4.1.1 Standard Serial Interface Configuration --------------------------------------------------- 36
4.4.1.2 Sandar Prosan Protocol Serial Interface Configuration -------------------------------- 36
4.4.2 Ethernet Interface -------------------------------------------------------------------- 36
4.4.2.1 Ethernet Connection ---------------------------------------------------------------------------- 36
4.4.2.2 Network Setup via the Serial Interface ----------------------------------------------------- 37
4.4.2.2.1 Start and Termination of the Configuration Program ---------------------------------------------- 37
4.4.2.2.2 1 set IP address ----------------------------------------------------------------------------------------------- 39
4.4.2.2.3 2 set netmask ------------------------------------------------------------------------------------------------- 39
4.4.2.2.4 3 set gateway -------------------------------------------------------------------------------------------------- 39
4.5 Maintenance of the Product ------------------------------------------------------- 39
5 Operation of the Product ---------------------------------------------- 40
5.1 Modes of Operation ----------------------------------------------------------------- 40
5.1.1 Local Mode ----------------------------------------------------------------------------- 40
5.1.2 Remote Mode ------------------------------------------------------------------------- 40
5.1.3 Auto Mode ----------------------------------------------------------------------------- 41
5.1.3.1 Autonomous Switching Functionality ------------------------------------------------------ 41
5.1.4 Individual/Simultaneous Switching Mode -------------------------------------- 44