Develop D 1650iD - Page 117

Error Messages
8
D 1650iD/D 2050iD 8-17
PAPER SIZE ERROR The paper loaded in the paper
tray caused a size error.
“#” indicates the paper tray,
and “XXX” indicates the paper
size.
Pull open the paper tray with the
size error, and then close it
again.
Check if a custom paper size
has been entered, and correct
the paper size using the
appropriate Utility mode
function.
(Flashing
alternately)
RESET PAPER (#XXX)
MEMORY FULL The size of the data for the
scanned image has exceeded
the capacity of the memory.
Press any key, or turn the
machine off, then on again.
(The scanned data should be
cleared from the memory.)
(Flashing
alternately)
PRESS ANY KEY
PC PRINT
MEMORY FULL
The image data received from
the computer has exceeded
the capacity of the memory.
Press any key, or turn the
machine off, then on again.
(The received image data
should be cleared from the
memory.)
SET PLUG-IN
COUNTER
A counter key is not inserted. Insert the counter key.
UPPER TRAY FULL If the optional Job Separator is
installed and the paper in the
Upper Copy Tray has reached
the maximum capacity,
printing cannot continue.
Remove all paper from the
Upper Copy Tray of the Job
Separator.
(Flashing
alternately)
REMOVE PAPER
TRAY MOVEMENT
ERROR
The optional Job Separator is
installed and the paper in
either the Upper Copy Tray or
the Lower Copy Tray has
reached the maximum
capacity when the machine is
turned on, when copying
begins, or when starting to
print.
Remove the paper from the
Upper Copy Tray or the Lower
Copy Tray of the Job Separator,
and then press any key.
(Flashing
alternately)
PRESS ANY KEY
CALL SERVICE(M1) A maintenance is due. Contact your service
representative.
CALL SERVICE(M2) The Imaging Unit should be
replaced.
Contact your service
representative.
MACHINE TROUBLE Some problem occurred in the
machine.
Turn the machine off, then on
again.
If the error is still displayed,
contact your service
representative.
(Flashing
alternately)
(C####)
Message Cause Remedy