Registering destinations 10-35
6 Press [OK].
Registering a program destination
The procedure for registering a program destination for scan transmissions is
described below.
Program destinations can be registered from the control panel of this
machine or from Web Connection. The following procedure describes how to
register from the control panel of this machine.
" For details on registering from Web Connection, refer to the [Refer-
ence Guide].
" For details on specifying a program destination to send scan data,
refer to “Selecting a program destination” on page 10-31.
1 Press [Scan to E-mail] or [Scan to Folder] to display the initial Scan to
E-mail or Scan to Folder mode screen.
2 Specify settings for the various parameters available from the [Settings]
screen.
– For details on the parameters available from the Settings screen, refer
to “Performing Scan to E-mail mode operations” on page 10-3 and
“Performing Scan to Folder mode operations” on page 10-17.
3 In the control panel, press the [Mode Memory] key.
The list of program destinations appears.
4 Press [Register].
5 Specify settings for [Name] and [Dest.] for the program destination, and
then press [OK].
– Press to display the address book screen. Select a registered
destination.
6 Press [OK].
[Favorites] For frequently used destinations, set to [ON].
This displays the destination in the [Favorites]
list, allowing it to be found more easily.
[Index] Select the index characters that will be used to
search for the destination.
To Next Page
Loading...
