[Admin Settings]3-46
[IPv6] Specify IPv6 settings.
[Enable] Settings [Yes] / [No]
Select whether or not to enable IPv6.
[Auto Setting] Settings [Enable] / [Disable]
Select whether or not to enable the IPv6 auto
setting.
[Link Local] Displays the link-local address.
[Global Address] Displays the global address.
[Gateway Address] Displays the gateway address.
[Netware] Settings [Enable] / [Disable]
Select whether or not to enable NetWare.
[AppleTalk] Settings [Enable] / [Disable]
Select whether or not to enable AppleTalk.
[Network Speed] Settings [Auto] / [10 Mbps Full Duplex] / [10
Mbps Half Duplex] / [100 Mbps Full
Duplex] / [100 Mbps Half Duplex] /
[1 Gbps Full Duplex]
Specifies the transmission speed for the net-
work and the transmission method for bidirec-
tional transmission.
[IEEE802.1X] Settings [Enable] / [Disable]
Select whether or not to enable IEEE802.1X.
[Binary Division] Settings [ON] / [OFF]
Select whether or not transmission data is
divided.
[S/MIME Settings] Specify S/MIME communication settings.
[S/MIME Enabled] Settings [Enable] / [Disable]
Select whether or not to enable S/MIME.
[Signature] Settings [Always sign] / [Never sign] /
[Select when sending]
Select the setting for digital signatures.
[Encryption] Settings [RC2-40] / [RC2-64] / [RC2-128] /
[DES] / [3DES] / [AES-128] /
[AES-192] / [AES-256]
Select the encryption method for the body of
E-mail messages.
To Next Page
Loading...
