Why does my DeVilbiss Paint Sprayer have a heavy top or bottom pattern?
If your DeVilbiss Paint Sprayer is producing a heavy top or bottom pattern, it could be due to plugged horn holes or an obstruction on the top or bottom of the fluid tip. Ensure you clean the horn holes and ream them with a non-metallic point. Also, make sure to clean the cap and/or tip seat.
Why does my DeVilbiss TEKNA PRO LITE have a heavy right or left side pattern?
If your DeVilbiss Paint Sprayer is producing a heavy right or left side pattern, it could be due to plugged horn holes on the left or right side, or dirt on the left or right side of the fluid tip. Clean the horn holes, reaming them with a non-metallic point, and clean the fluid tip.
How to fix runs and sags with my DeVilbiss Paint Sprayer?
If your DeVilbiss Paint Sprayer is producing runs and sags in the finish, it could be due to several factors. You might have too much material flow, so try adjusting the gun or reducing the fluid flow. The material might also be too thin, so mix it properly or apply lighter coats. Finally, make sure you're holding the gun at a right angle to the work and using proper gun technique.
Why is fluid leaking from the packing nut of my DeVilbiss Paint Sprayer?
If your DeVilbiss Paint Sprayer is leaking fluid from the packing nut, try tightening it, being careful not to bind the needle. If that doesn't solve the problem, the packing might be worn or dry, in which case you should replace or lubricate it.
Why is my DeVilbiss Paint Sprayer leaking fluid from the front?
If your DeVilbiss Paint Sprayer is leaking or dripping fluid from the front, the packing nut might be too tight, so adjust it. The packing could also be dry, so lubricate it. If the fluid tip or needle is worn or damaged, replace them. Check for any foreign matter in the tip and clean it. If the fluid needle spring is broken, replace it. Finally, ensure you are using the correct size needle and tip.
How to get round spray with my DeVilbiss TEKNA PRO LITE Paint Sprayer?
If you're unable to get a round spray from your DeVilbiss Paint Sprayer, the spreader adjustment screw might not be seating properly, so try cleaning or replacing it. Also, check if the air cap retaining ring is loose and tighten it.
Explains the spray gun's design, function, and capabilities for various coating materials.
Key technical parameters including air connection, pressure, flow rate, and weight.
Identifies potential hazards like fire, toxic substances, and explosion, with corresponding safeguards.
Step-by-step guide for mixing, filling, and spraying using the gun.
Diagram showing all spray gun parts with reference numbers and part numbers.
Diagnose and correct common spray gun operational issues and patterns.
General| Fluid Adjustment | Yes |
|---|---|
| Air Adjustment | Yes |
| Pattern Adjustment | Yes |
| Type | HVLP |
| Air Cap Options | HVLP, High Efficiency |
| Air Inlet Size | 1/4 inch |
| Max Air Pressure | 29 psi |
| Material | Aluminum |
| Fluid Nozzle Size | 1.3 mm |
To Next Page