Dieci Apollo 25.6 - Water Heater (Optional

C/46
Getting to Know and Using the Vehicle
Mod. Apollo
- ATTENTION: - Read the SAFETY REGULATIONS (contained in this manual) carefully for the safety of all personnel and your vehicle.
WATER HEATER
(OPTIONAL)
(g.100/C Pos.”1”)
Located at the rear of the bonnet.
- ATTENTION:
Before switching on the water heater, carry out the opera-
tions included in Chapter B “STOPPING UPON COMPLE-
TION OF WORK”
System operation:
1. Plug in connector “A” into socket “B” located in the rear
part of the engine bonnet (g.101/C).
2. Insert plug “C” into the electric socket (g.101/C).
The heater is connected to its own control unit and maintains
engine water at a temperature higher than the external
temperature (in cold climates).
In the event of malfunction contact a DIECI service centre.
- ATTENTION:
Verify the good conditions of the power supply cable before
starting up the device.
- ATTENTION:
Do not use the water heater with the engine on and while the
vehicle is moving.
- ATTENTION:
Remove water heater power supply before switching on and
moving the vehicle.
7-POLE ELECTRIC SOCKET FOR TRAILER
(OPTIONAL)
(g.102/C Pos.”A”)
Located at the rear of the vehicle.
- ATTENTION:
Before moving the vehicle with the trailer:
- Ensure that the brake and signalling systems are fun-
ctioning properly.
- Verify that the trailer conforms to regulations in force in
the country where the vehicle is being used.
A
B
C
(g.101/C)
(g.100/C)
(g.102/C)
1
A