Dieci Apollo 25.6 - General Alarm Led; Engine Error; Switch-On of Dashboard Indicator Lights; Engine Overrevving

- ATTENTION: - Read the SAFETY REGULATIONS (contained in this manual) carefully for the safety of all personnel and your vehicle.
C/61
LED 1 LED 2
Acoustic signal (Buzzer)
Coupling 1
YES ( 1.5 seconds)
Coupling 2
YES ( 1.5 seconds)
Coupling 3
YES ( 1.5 seconds)
Coupling 4
YES ( 1.5 seconds)
Coupling 5
YES ( 1.5 seconds)
(g.205/C)
GENERAL ALARM LED
The emergency indicator light/general alarm occur:
- in the event of engine error
- if one of the indicator lights indicated in the table below should switch on
- in the event of engine overrevving
Engine error
The engine has an electronic control unit that communicates directly with the central dashboard. The anomalies are signalled
by the general alarm indicator light accompanied by the acoustic signal with duration of 1.5 seconds and the display of the error
code on the LCD.
Switch-on of dashboard indicator lights
Some signal indicator lights, which are particularly important for the duration and use of the same in complete safety have been coupled
tothegeneralalarmindicatorlight(g.205/C)withacousticsignallasting1.5seconds.Theacousticsignalfunctionsonlywiththe
enginerunning.Thesignallingofalarmsbytheindicatorlight“1”(g.205/C)haspriorityoverothersignalsthatthiscommunicates.
Engine overrevving
The overrevving condition is signalled by reaching 3000rpm on the rev. counter.
Theconditionissignalledbytheswitch-onofthegeneralalarmlightintermittentlyandtheacousticsignal(buzzer)continuously.
The alarm will stop when the engine has dropped below 3000rpm.