Maintenance and Registering
D/18
Mod. Apollo
- ATTENTION: - Read the SAFETY REGULATIONS (contained in this manual) carefully for the safety of all personnel and your vehicle.
HYDROSTATIC OIL FILTER
(g.13/D pos.”1”)
Operate as follows to correctly replace:
1. Park the vehicle on a level surface.
2. Fully retract the boom and lower it.
3. Switch off the engine and remove the ignition key, hang up
a sign in the cab that reads “maintenance work under way”.
4. Place a container under the filter to collect any oil that
may come out during replacement.
5. Close the valve of the “supply tube lter” (g. 14/D Pos. “1”).
6. Remove the lter cartridge, unscrewing it using a ribbon
spanner (g.15/D).
7. Clean the lter support with a clean cloth which will not
leave felt, making sure the old sealing ring is removed.
8. Take the new DIECI-approved filter. Lubricate with the
same oil as used on the oil seal gasket.
9. Screw in the lter using only your hands, taking care to
set the lubricated oil gasket in its proper position.
10.
- ATTENTION: open the “supply tube lter” valve and
block it with a nylon clamp.
11. Switch on the vehicle and make sure there are no leaks.
- ATTENTION:
Waste oil is potentially harmful to the environment and must
be disposed of properly.
(g.13/D)
(g.15/D)
(g.14/D)
1
1
To Next Page
Loading...
