Dieci Apollo 25.6 - FIRE PREVENTION

B/23
- ATTENTION -
IF A FIRE DEVELOPS, IMMEDIATELY ABANDON THE
MACHINE AND FIND A SAFE PLACE; IF POSSIBLE TURN
THE IGNITION TO "0" (ENGINE AND INSTRUMENTS OFF)
BEFORE ABANDONING THE MACHINE.
- ATTENTION -
ONLY TRY TO PUT OUT THE FIRE IF IT IS SMALL AND IF
YOU HAVE AN OF A CORRECTLY MAINTAINED EFFI-
CIENT EXTINGUISHER
- ATTENTION -
IF THE FIRE DIRECTLY INVOLVES THE OIL OR FUEL
TANK, ABANDON THE MACHINE IMMEDIATELY; THE
MACHINE COULD EXPLODE.
FIRE PREVENTION
- ATTENTION -
Stop the machine immediately if an alarm lights up in
the cab. Contact your DIECI service centre and do not
operate the machine until the fault has been repaired.
- Before every work cycle, ensure there are no leaks from
the machine; fuel, oil, grease or lubricants in general can
start res and cause serious injury.
- Regularly check there are no loose or missing clamps,
no twisted hoses or hoses that are rubbing together.
- Do not bend any pipes under pressure. Never install da-
maged pipes.
- Remove inammable materials such as fuel, oil, grease,
waste, deposits, accumulated dust or any other compo-
nents that can start a re.
- Avoid short circuits; they can cause res.
- Regularly clean and secure all electrical connections. Befo-
re every work shift, ensure there are no twisted, hardened
or damaged electricity cables. If there is a malfunction, do
not start the machine and contact a DIECI service centre.
- Regularly check the ignition switch. A fault when stop-
ping the engine will obstruct the work of the re brigade.
- When cleaning parts with oil, use non-inflammable oil.
Diesel and petrol fuel can catch re. Do not use.
- Do not weld or use a cutting torch to cut pipes that con-
tain inammable liquids.
- When checking the level of fuel, oil, battery electrolyte,
windscreen wiper liquid or coolant, always use an ex-
plosion proof light source. If other types of lighting are
used, there is a risk of explosion.