C/27
- ATTENTION: - Read the SAFETY REGULATIONS (contained in this manual) carefully for the safety of all personnel and your vehicle.
BOOM CONTROL LEVER (Fig.50/C Pos.”1”)
This lever is found to the right of the operator (fig.50/C
Pos.”1”). It is used to manoeuvre the boom and its extremities.
- ATTENTION:
Before using the boom make sure that the surrounding area
is free. Make sure that the loads to be raised correspond
with the capacity diagrams of the vehicle.
- ATTENTION:
The instructions refer to the standard version at the time
of printing. In there are special options or following techni-
cal updates, lever movements may correspond to different
controls. For this reason, always refer to instructions present
inside the driver’s cab.
- ATTENTION:
The Manufacturer offers a range of levers (Joysticks) for boom
movement with different technical specifications and those
different than the standard version (see following pages).
1
(g.50/C)
To Next Page
Loading...
