C/52
Getting to Know and Using the Vehicle
Mod. Apollo
- ATTENTION: - Read the SAFETY REGULATIONS (contained in this manual) carefully for the safety of all personnel and your vehicle.
Disengaging the negative parking brake with the engine
stopped
1° Loosen the screws on both sides (fig.143/C-144/C
pos.”1”) of the centre part of the front axle (Do not com-
pletely loosen the screws; loosen them only enough so
that described in point 2 can be carried out).
2° Remove the “U” shaped liners (g. 145/C, pos.”1”).
3° Re-tighten screws until they fit into position. In these
conditions it is possible to tow the vehicle.
4° To return the brake to working condition, return in to its
original conditions.
- ATTENTION -
Once the maintenance/transport operations have
been completed, place the brake back in working
condition, restoring its original conditions.
(g.143/C)
(g.144/C)
(g.145/C)
1
1
1
To Next Page
Loading...
