- To prevent damaging hydraulic connections when chan-
ging an attachment, stop the engine and wait a minute
to remove pressure from the circuit. Always clean con-
nectors before their reinsertion.
- Check the cleanliness, protection and the conditions of
rapid detachment connections in attachment circuits daily.
- ATTENTION -
Operators who note that the vehicle is not operating pro-
perly or that is does not conform to safety regulations
must immediately inform the construction site manager.
- PROHIBITION -
IT IS FORBIDDEN for operators to directly carry out
repair or adjustment work unless trained to do so. Only
the person charged to do so should carry out mainte-
nance work on the vehicle.
- PROHIBITION -
IT IS STRICTLY FORBIDDEN to attempt starting the vehi-
cle by pushing or pulling on it. This may cause serious
damage to people and/or the vehicle.
- If operating the vehicle at low temperatures (-10°C),
empty and rell the tank using lubricants, fuel or cooling
liquids suitable for such temperatures.
- ATTENTION -
The use of the vehicle in protected environments such as
reneries or explosive atmospheres is STRICTLY PROHI-
BITED. Special optional equipment is available for use in
these types of locations. Contact your agent or dealer.
- Ensure that service brakes and horn are working properly.
- Slow down before turning.
- Maintain control of the vehicle and its speed in all situations.
- Do not drive in reverse for long distances.
- Brake slowly, avoid abrupt braking.
- Hydraulic steering is very sensitive to steering wheel mo-
vements. Steer slowly and avoid any sudden movements.
- The speed of vehicles with loads must never exceed 10
Km/h. Should the load exceed 50% of the maximum admit-
ted load, the machine speed must be reduced to 5Km/h.
- PROHIBITION -
Carrying people on or lifting people up with the vehicle
is STRICTLY PROHIBITED unless the vehicle is equip-
ped for said purpose and has a special certificate of
conformity regarding the transport of people.
- Carefully follow loading programme instructions.
- ATTENTION -
Before each use, check that attachments have been proper-
ly mounted and secured on their corresponding supports.
- ATTENTION -
Prior to each use, check that the cab safety system has
been set in compliance with the mounted attachment.
- Instructions supplied by the anti-tipping system must be
considered valid for vehicles in standard working condi-
tions, on at, even ground and with properly functioning
and correctly calibrated instruments. Regardless, limit va-
lues displayed on the load tables must never be exceeded.
- Never bring equipment near open ames.
To Next Page
Loading...
