Dieci Apollo 25.6 - Page 49

B/28
Mod. Apollo
Safety Regulations
- ATTENTION -
WHEN MOUNTING A NEW OR REPAIRED TYRE, USE AN
ADAPTER FOR THE SPRING VALVE WITH A DISTANCE
MANOMETER WHICH ALLOWS THE OPERATOR TO
KEEP AWAY FROM THE TYRE DURING INFLATION.
USE A SAFETY FENCE SYSTEM.
- Do not inate a tyre unless the rim is mounted on the ve-
hicle or secured so that it will not move in the event that
the tyre or rim should suddenly break.
- Never inflate tyres in excess of the pressure indicated
by DIECI. If the heel does not settle on the rim when this
pressure level is reached, deate the tyre and lubricate
with a soapy water solution, then inflate again. Do not
use oil or grease. Ination exceeding the permitted level
on unsettled heels can cause heel or rim breakage with
an explosive force that can cause serious injury.
- PROHIBITION -
DO NOT MOUNT INFLATED TYRES WITH POLYURETHANE
FOAM UNLESS AUTHORISED BY THE MANUFACTURER.
- Do not re-inate a tyre which has completely turned or
that is very deated until it has been properly inspected
by a qualied technician.
- After having remounted the wheel, tighten the nuts
between the wheel and axles. Check that nuts are tighte-
ned each day until torque has stablised.
Replacing a tyre on the road
- When a tyre must replaced along the road, proceed as
follows:
If possible, park the vehicle on at, even ground.
Engage the parking brake.
Switch off the engine.
Engage emergency lights.
Put wedges under tyres opposite from the tyre to be replaced
in order to block the vehicle from moving in both directions.
Loosen the bolts of the tyre to be replaced.
Place the jack under the half-box of the axle, as close as
possible to the tyre.
Lift the tyre until it comes off the ground; position the sa-
fety support under the axle.
Completely unscrew the bolts from the tyre and remove them.
Remove the tyre with "push and pull" rotating movements.
Insert the new tyre on the hub.
Manually screw in bolts. Lubricate them with grease if
necessary. Tighten bolts securely with a torque wrench.
Remove the safety support and lower the telehandler
with the jack.
Re-tighten bolts to the tyre securely with a torque wrench.