Digi AnywhereUSB Plus Series User Manual

Get started Verify product components
AnywhereUSB® Plus User Guide
16
Item Name Description
3
SFP+ Connect an SFP transceiver module for fiber connection, such as Finisar
Network FTLX8574D3BCL SFP+.
4 DB9
console
Used to access a console using the RS232 DTEinterface.
5 Fan
The LED shows the status of the fan:
n Solid green when the fan is running within normal range of use.
n Solid red if the fan slows down or the Hub is overheating.
5 Wi-Fi
Service
Reserved for future use.
5 User
LED used for the Find Me feature. When this feature is activated, the
LED blinks orange and then green. You can configure the Find Me
feature in the web UI or by using the findme CLI command.
5 Power The LED is solid blue when the Hub is powered.
5 WWAN1
Signal
Reserved for future use.
5 WWAN1
Service
Reserved for future use.
6 BT Reserved for future use.
7 Wi-Fi1 Reserved for future use.
8 Wi-Fi2 Reserved for future use.
9 Wi-Fi3 Reserved for future use.
10 Wi-Fi4 Reserved for future use.
11 WWAN2 Reserved for future use.
12 WWAN1 Reserved for future use.
13 Reset
button
Use this button to reset the AnywhereUSB® Plus Hub configuration to
factory defaults. See Use the Reset button to restore factory defaults.
14 Power
connector
Connect the power supply.

Digi AnywhereUSB Plus Series Specifications

General

Brand	Digi
Model	AnywhereUSB Plus Series
Category	Switch
Language	English