Initial setup Physical installation
Digi EX15 User Guide
19
1. Plug the power supply unit into an AC power outlet and connect to the PoE injector.
2. Connect the male RJ45 connector plug of the POE injector cable to the site network
equipment/router.
3. Connect a standard Ethernet cable from the RJ45 socket/jack on the POE injector cable,
(marked DC OUT), to the LAN/PoE Ethernet port of the Digi EX15.
Remote power troubleshooting
The LED marked IN will illuminate when the PoE injector is receiving power from the PSU. The LED
marked OUT lights up green when an Ethernet connection is recognized by the Digi EX15.
If the IN LED is not illuminated check the following:
n Ensure that the PSU is plugged into an AC power outlet and is receiving power.
n Ensure that the PSU power plug is correctly connected to the POE injector cable power input
socket.
If the OUT LED is not illuminated after connecting to the Digi EX15, verify the integrity of the Ethernet
cable.
Note The PoE injector must be connected to LAN port 1 on the Digi EX15 for the device to properly
receive power.
To Next Page
Loading...
Need help?
General