Initial setup Default settings
Digi EX15 User Guide
21
Default settings
Option Default settings
Ethernet
ports
n Port 1 is configured as a LAN port in passthrough mode and will receive the
passthrough IP address of the Digi EX15 cellular modem connection.
n Port 2 is configured as a WAN port and will accept a DHCP IP address from
an existing local network router.
Interface
priorities
n WAN is set at a metric of 1.
Note This metric sets the WAN port as the Digi EX15 primary network
connection.
n Modem (cellular) is set at a metric of 3.
Modem
configuration
n SIM failover after 5 attempts.
n Carrier Smart Select enabled.
Network
settings
n The Digi EX15 is configured to run in passthrough mode by default.
WAN failover
conditions
n Connectivity monitoring enabled for WAN.
n HTTP and Ping test: 4 attempts set a 30s interval.
Security
policies
n Packet Filtering set to block all inbound traffic.
n SSH, Web Admin, and Local GUI access enabled.
Configuring the device
Network managed configuration
Your Digi EX15 has the capability to automatically sync and receive all settings from a centralized
cloud management tool, aView.
The aView management portal provides the following capabilities:
n Monitoring details including signal strength, network connectivity details (RSRP, CNTI, RSRQ,
Ec/Io, and so on), SIM card details (IMEI, IMSI, ESN, and so on), data transmitted/received, and
more.
n Email notifications based on connectivity, device firmware, and signal strength.
n Remote control.
n Out of band SMS recovery.
Devices using aView typically require no additional configuration or setup.
To Next Page
Loading...
Need help?
General