About aView
The following actions are typically performed by your network administrator.
Changes can be made either at the device or group level. Select override from any given menu item to
edit its inherited value, or navigate to the Digi EX15 group configuration page to update the config
profile shared between all devices belonging to this group.
It is recommended that aView centrally manages the Digi EX15 devices; only resort to local
management as necessary. For any questions regarding how to access aView, please contact Digi
support or your purchasing partner.
Viewing and editing group configurations
To bring up a device in the configuration portal:
1. Use the search bar to filter devices by MAC address.
Note The device MAC address is on its bottom label.
2. Select the MAC address of your unit and bring up its Details page.
3. Navigate to the Configuration tab of the left-side menu.
4. Follow the Edit Group Configuration link.
5. Adjust the necessary settings, clicking the Update button to apply any changes.
Devices will automatically apply configuration updates after the next daily sync (1am UTC by default).
Refer to Using remote commands for details on how to apply changes sooner.
Upgrading firmware
WARNING! When the Digi EX15 is updating firmware, its LEDs will flash red and yellow.
Do NOT remove power from the device during this process.
To view or select new firmware:
1. Navigate to the Configuration tab of the left-side menu.
2. Follow the Edit Group Configuration link.
3. Locate the Firmware pull-down menu.
4. Select the intended version and wait for the settings to finish loading.
Digi EX15 User Guide
28
To Next Page
Loading...
Need help?
General