Troubleshooting Using Terminal on Unit link
Digi EX15 User Guide
48
Once you apply the new configuration to the Digi EX15, reboot the device so it rebuilds the IPSec
tunnel and reports the new IPSec local IP address to aView. You can verify that aView is using the
IPSec local IP as the management IP by looking at the Uplink IP address on the Device Details tab.
This value should be set to a 172.x.x.x IP address.
Using Terminal on Unit link
Once the correct management IP is reported from the Digi EX15 to aView, click the Terminal on Unit
to open a page on aView that provides access to the Digi EX15 console. Default login credentials are
below.
User: root
Password: The default password is located on the bottom of the device.
To Next Page
Loading...