UTM-00339 | Rev 19
Page 11 of 253
DetNet South Africa Copyright © 2021
This manual details the operation of the DigiShot
®
Plus 4G Commander System.
Only trained personnel, and personnel found competent, are allowed to operate the system.
Users of the system shall be aware of the recommended procedures for using the DigiShot
®
Plus 4G
Commander System as per manufacturer’s recommendations.
These recommendations do not supersede the method as required by local mine, explosives or statutory
regulations/procedures/codes of practise regarding the use of detonators. In such cases, the MOST
STRINGENT set of rules between the mine, explosives or local regulations/procedures/codes of practise and
the manufacturer must be followed.
Training and software upgrades shall only be performed by a DetNet SA subject matter expert.
Contact the DetNet head office for additional information.
ALL USERS OPERATING THE DIGISHOT
®
PLUS 4G COMMANDER SYSTEM SHALL HAVE SUCCESSFULLY
COMPLETED THE SPECIFIC TRAINING BEFORE PERFORMING ANY WORK WITH THE DEVICE(S).
This manual is only to be used for the DigiShot
®
Plus 4G Commander System and the
applicable software version as displayed.
To Next Page
Loading...