DigiShot plus.4G - Remote Blast

To Next Page

To Previous Page

UTM-00339 | Rev 19

Page 187 of 253

5. Arm

• Press button to select Remote Blast

ARM AND FIRE COMMANDS FOR DETONATORS WILL NOT INITIALLY BE KNOWN TO THE DIGISHOT

PLUS

4G COMMANDER AT POWER ON. THESE COMMANDS ARE ONLY AVAILABLE FROM THE BLASTING (RED)

BLASTCARD AND WILL BE ISSUED TO THE COMMANDER WHEN NECESSARY, EITHER DIRECTLY FROM THE

RED BLASTCARD (IN CASE OF A LOCAL BLAST) OR REMOTELY FROM THE BASE DIGISHOT

PLUS 4G

COMMANDER. ARM AND FIRE BLASTING COMMANDS WILL BE ERASED FROM THE COMMANDER MEMORY

AFTER USE.

6. Remote Blast

• Press SoftKey to initialise RF communication

• User may change RF settings by selecting corresponding numbers. Refer to 15.3

for detailed RF settings procedure.

7. Remote Blast

• User will be prompted to Scan Key

• Scan the Yellow BlastCard at the back of the DigiShot

Plus 4G

Commander

8. Remote Blast

• Press and hold the NEXT button on the front

of the DigiShot

Plus 4G Commander for 2 seconds

• The DigiShot

Plus 4G Commander will initiate a

Grace period of 2 minutes.

Yellow NFC card must be from the same group as Red NFC card for RF communication to

take place.

BLAST CARD NFC SENSOR