UTM-00339 | Rev 19
Page 16 of 253
DetNet South Africa Copyright © 2021
The host device shall be properly labelled to identify the modules within the host device. The certification label of
the module shall be clearly visible at all times when installed in the host device, otherwise the host device must be
labelled to display the FCC ID and IC of the module, preceded by the words "Contains transmitter module", or the
word "Contains", or similar wording expressing the same meaning, as follows:
Contains FCC ID: 2ARNH-15351660 (AC4490 RF module)
2ARNH-1535166A (CC1120 RF module)
L'appareil hôte doit être étiqueté comme il faut pour permettre l'identification des modules qui s'y trouvent.
L'étiquette de certification du module donné doit être posée sur l'appareil hôte à un endroit bien en vue en tout
temps. En l'absence d'étiquette, l'appareil hôte doit porter une étiquette donnant le FCC ID et le IC du module,
précédé des mots « Contient un module d'émission », du mot « Contient » ou d'une formulation similaire exprimant
le même sens, comme suit :
Contains IC: 24476-15351660 (AC4490 RF module)
24476-1535166A (CC1120 RF module)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de classe B est conforme à la norme canadienne ICES-003.
The table below is to be used as a guide for the recommended minimum operational and safety distances of the
DetNet electronic blasting systems and detonators. This will apply for transmitters up to 100W power output within
the frequency range of 150KHz to 6GHz. These are general recommendations and specific frequencies can be
tested for on request if shorter distances are required. The 10V/m and 30V/m field strengths are based on ARP 1717
and EN13762-27 specifications. Protection against Electrostatic Discharge immunity (ESD) of the detonator and
DetNet equipment were tested with reference to the Human Static mode and the required standards.
All DetNet equipment complies with the required standards: ARP 1717, EN 13763-27 for Initiation Devices and
Initiation Device Systems.
To Next Page
Loading...