UTM-00339 | Rev 19
Page 224 of 253
DetNet South Africa Copyright © 2021
This function enables the user to change the device password by assigning a new unique password that is known
only to the user.
1. Main Menu
• Press to select Configuration
2. Configuration Menu
• Press to select Advanced Setup
3. Advanced Setup
• Press to select Device Password
4. Passwords
• Use the numerical keypad to enter Current Password.
• Press to confirm.
• Use the numerical keypad to enter New Password.
• Press to confirm.
• Information message confirming password changed
will be displayed briefly.
• Advanced Menu will be displayed.
Unlike conventional password entry, the chosen password is visible to the user (rather
than ****) to enable the user to see if any typing errors are being made.
Leaving the new password ‘blank’ disables the password request when the Commander is
switched on.
To Next Page
Loading...