DigiShot plus.4G - Page 33

UTM-00339 | Rev 19
Page 33 of 253
DetNet South Africa Copyright © 2021
The DigiShot
®
Plus 4G Detonator cannot be initiated by the CE4 Tagger. The CE4 Tagger is incapable of producing
the required firing voltage and cannot produce the required ‘Fire’ command to initiate a DigiShot
®
Plus 4G Detonator.
NEVER CONNECT ANY THIRD PARTY OR OTHER UNAPPROVED DETONATORS TO THE DIGISHOT
®
PLUS 4G
COMMANDER SYSTEM.
HANDLE MECHANICALLY DAMAGED 4G DETONATOR AS PER APPROVED PROCEDURES. NEVER CONNECT
THE 4G DETONATOR TO ANY UNAPPROVED VOLTAGE SOURCE. NEVER CONNECT THE 4G DETONATOR
TO ANY EQUIPMENT OTHER THAN A CE4 TAGGER WHILE ON THE BENCH. THE 4G DETONATOR MAY BE
CONNECTED TO THE COMMANDER AS PER LOCAL LEGISLATIVE REQUIREMENTS AND PRESCRIBED
BLASTING PRACTICES ON SITE WHICH MAY REQUIRE THE BENCH TO BE CLEARED FOR BLASTING BEFORE
CONNECTION TO A BLAST DEVICE IS ALLOWED
Refer to Destruction of Shot Detonators document OPI-202 for guidelines. The guideline does not supersede
those required by local mine, explosives or statutory regulations/procedures/codes of practise regarding the use of
4G detonators. In such cases, the MOST STRINGENT set of rules between the mine, explosives or local
regulations/procedures/codes of practise and the manufacturer must be followed.
Always keep connectors closed when not in use to avoid damage and/or contamination.
Always ensure all the DigiShot
®
Plus 4G Detonators are connected to the system via the
harness wire before leaving the bench.
DigiShot
®
Plus 4G Detonators are impact sensitive and should always be handled with
care.