Setup procedure for WDS or WDS+AP:
In this mode, you can expand the scope of the network by combining up to four other
access points together.
Here is the description of every setup item:
Parameter Description
Enable SSID
Broadcast
If Enabled, the Wireless Access Point will broadcast its
name (SSID) to all Wireless Stations. Stations which have
no SSID (or a null value) can then adopt the correct SSID
for connections to this Access Point.
Enable Wireless
Isolation
If checked, the wireless client under this SSID can only
access internet and it can’t access other wireless clients
even under the same SSID, Ethernet clients or this device.
Other clients can’t access the wireless client, either.
Name(SSID) Input the SSID of your wireless router, the
be the same with other wireless routers for the
convenience of roaming.
Mode Select the mode you want to use; all the wireless routers
must use the same setting.
Channel Select the channel you want to use; all the wireless routers
must use the same setting.
Band Width Select any channel width from the pull-down list. The
To Next Page
Loading...
