DigiTech DigiGate-700 User Manual

DigiGate-700
for Windows
™ ®
G - 5DigiGate-700
™
for Windows
®
- User’s Guide
Figure G-5
Figure G-6
NOTE: This error, Figure G-5, can occur
during Move In, Move Out, Download All, etc.
It is normally associated with a database
problem. It can be caused when there is no
mux/slot or alarm zone defined for the unit in
question.
1. Click on the OK button.
2. If you know the unit causing the problem, check
that the information above is correct.
3. If the error persists, call your Reseller or the
Digitech International, Inc. service depart-
ment.
NOTE: This error is reported from the
Microsoft Backup program. The backup set
shipped with the DigiGate-700 for Windows
program will operate correctly only when the
computer is named My Computer . If named
something else, the message above appears.
1. Click on the OK button.
2. Check the computer name and if different,
either rename it or create a new backup set for
your computer or backup device. See the
section “Creating Backup Sets” in “Chapter 5,
Backing Up Your Data.”.
3. If the error persists, call your Reseller or the
Digitech International, Inc. service depart-
ment.

DigiTech DigiGate-700 Specifications

General

Brand	DigiTech
Model	DigiGate-700
Category	Other
Language	English