Storing the Program
1. When you have the name how you want it, press the <Store> button again. The top line of the display appears something like this:
This screen allows you to select the location of the new Program. Note that when the Program is stored, it is stored in the User bank of
programs because factory programs cannot be overwritten.
2. Press the <2> button and then turn the <Data> wheel to select the program number where you want to store the new program.
3. Press the <Store> button again. The top line of the display briefly reads:
after which you are taken to the program you have just stored.
The newly created program is now loaded, and can now be recalled at any time.
4. To abort the procedure, push the <Program> button to return you to program mode.
To Next Page
Loading...
