Assigning Parameter control to Footswitches or the Expression Pedal
The RP-20 Valve allows you to control up to 16 Parameters per Program. Each time you link a parameter to a footswitch or expression pedal, it
is added to any assignments already made to that controller. This is where the RP-20 Valve becomes the dedicated work horse that it is, by
doing all of the organizing for you so all you have to do is select which parameter is being controlled, then tell the RP-20 Valve to “Make it so”.
To assign any currently selected Parameter to a footswitch or Expression pedal in the currently selected bank, do the following:
1. Be sure that the parameter you want to link is displayed and selected. Once the parameter has been selected, press the <Assign> button
and the display will appear like this:
2. Now press the footswitch that you wish assign and the display will appear something like this if the footswitch is already assigned to
control another parameter:
3. If you wish to re-assign, press the <3> button. If you don not wish to re-assign the footswitch, press the <4> button and now the
footswitch is assigned to the selected parameter.
To Next Page
Loading...
