DigiTech RP-20 VALVE - Global-Local Cabinet Emulator; Output Mode

Global vs. Local Cabinet Emulation
The thing to factor in when using the Cabinet emulator in either global or local mode is whether or not you want all of your sounds affected by
this change. A good time to use Global mode is when your frequently playing in different venus (because each room always sounds different).
The procedure for selecting either the Local or Global Cabinet emulation is as follows:
1. Press the <Utility> button and then press either <Next or Previous> page button until you reach page 2 of the Utility page. The display
reads:
2. By pressing the <4> button and then turning the <Data> wheel, you can set the Cabinet Emulator to either Local On or Global On
mode, or Global Off.
Output Mode
You can output the signal of your RP-20 Valve as either a Stereo or Mono signal.
1. Press the <Utility> button and then press either the <Next or Previous Page> buttons until you reach page 1 of the Utility page using.
The display reads:
2. Pressing the <2> button and then turning the <Data> wheel, you can turn set your RP-20 Valve to output either a Stereo or Mono
signal.
Output:Mono
2
FACTORY USER
%kHz
msdB
1
CHANGEDLINK

%kHz
msdB
1
2
CHANGEDLINK
%kHz
msdB
3
CHANGEDLINK
4
CHANGEDLINK
PAGE
1
OF 13
COMP WAH TUBE EQ
L/R OUTS
L/R OUTS
#
b
GATE
BANK
Cabinet Emulator: Local
2

USER
%kHz
msdB
1
CHANGEDLINK

2
CHANGEDLINK
%kHz
msdB
3
CHANGEDLINK
%kHz
msdB
On
4
CHANGEDLINK
PAGE
2
OF 13
COMP WAH TUBE EQ
L/R OUTS
DIGITAL
#
b
GATE
BANK
EQDIST
Section - 5 Advanced Topics
RP-20 Valve
User Guide
62