Expression Pedal
The RP-20 Valve has a built-in expression pedal for the assignment of continuous control over any effect parameter.
The assignment procedure to be followed is listed below.
Linking a Parameter to a Modifier
To link a parameter to a Modifier, please complete the following steps:
1. Scroll to the parameter you would like to link to a modifier (ie: Delay feedback).
2. Press the <Assign> button and the display appears something like:
3. Now press the <1> button and turn the <Data> wheel to turn the link for that parameter on. The display will look something like this:
4. Press the <2> button and then turn the <Data> wheel to scroll through the different modifiers that can be linked to the parameter you
want assigned. The selections are:
MIDI CC’s
(CC): 0-127 & ChP
(aftertouch)
Real Time modifiers (RT):
LF1, LF2, dY1, & dy2
Int Pedal
(Int)
NOTE: The MUTE and THRU effect types do not have any Parameters to connect to, so they will not appear in the parameter list.
5. Press the <3> button and turn the <Data> wheel to select the minimum parameter value you want when the controller is in the
maximum position.
6. Press the <4> button and turn the <Data> wheel to select the maximum parameter value you want when the controller is in the
maximum position.
NOTE: Make sure you store any changes you want to save before moving on.
To Next Page
Loading...
