Setting up an LFO
To set up an LFO that is linked to an effect parameter, the procedure is as follows:
1. Enter Assign Mode by pressing the <Assign> button.
2. Use the <Data> knob to scroll to the LFO page. The display looks something like:
3. You can press the <1> and turn the <Data> wheel to select which of the two LFOs you want to adjust.
4. Press the <2> button and turn the <Data> wheel to turn the LFO on or off.
5. Press the <3> button and turn the <Data> wheel to change the selected LFO's waveform. You can select SINe, TRIangle, SPecial1,
SPecial2.
6. Press the <4> button and turn the <Data> wheel to adjust the speed of the LFO cycle.
Any parameters assigned to the LFOs will now follow the modulating waveform of the LFO you selected.
Setting up a Dynamic Modifier
1. Enter assign Mode by pressing the <Assign> button.
2. Use the <Next Page> and <Previous Page> buttons to scroll to the first of two Dyn pages. The display looks something like:
3. You can press the <1> button and turn the <Data> wheel to select which of the two Dyns you want to adjust.
4. Press the <2> button and turn the <Data> wheel to turn the Dyn on or off.
5. Press the <3> button and turn the <Data> wheel to set the threshold above which dynamic modification of the parameter begins.
To Next Page
Loading...
