Notice in the bottom left corner of the display (just under the program number) the display indicates which page you
are on and the total number of pages within the module. Each page allows you to access up to four parameters using the <1> - <4> buttons
to select the parameter and the <Data> wheel will move you through the selected parameter.
Example:
To scroll through the parameter pages of the Dual Chorus module, from the Program mode press the <Effects> button on the front panel
until the module you wish to edit comes up in the display. Now press the <2> button and then turn the <Program/Effect> wheel to
scroll to the Dual Chorus module. At this point use the <Next Page> or <Previous Page> buttons to scroll through the parameters of the
Dual Chorus module.
For a description of all the FX Modules and their parameters, see pages 30-50.
Output Module Functions
The last module in the audio chain within any program of the RP-20 Valve gives you control over crucial output functions of the RP-20 Valve
such as: Master Mix, Master Volume and On and Bypass of the cabinet emulator for each program.
1. To access the Output module, press the <Effects> button until the display appears like this:
2. Pressing the <3> and <4> buttons and then turning <Data> wheel will let you set the Dry and Wet levels in the selected program.
3. By pressing the <Next or Previous Page> buttons, you will now be taken to page 2 of the Output module and the display will appear
like this:
4. The <1> button is used to turn the Cab emulator on or off and the <2> button is used to select the Cabinet emulator type. The <3>
button is used to se the position of the cabinet emulator in the audio chain.
To Next Page
Loading...
