Other Footswitch Functions
The footswitches on the RP-20 Valve can be assigned to do several functions. This is done through the Foot Controller menus in the Utility
section of the RP-20 Valve. These functions include:
Toggle MIDI CC: This function allows you to send MIDI Continuous Controller (CC) information out the MIDI port while the footswitch
still maintains its ability to control a parameter directly. When assigned to a footswitch, CC values 0 or 127 are sent. CC numbers 0 through
127 are available.
Expression CC send: The Expression pedal of the RP-20 Valve can also send MIDI CC data to other MIDI devices.
The procedure for setting up a MIDI CC toggle footswitch function is as follows:
1. Press the <Utility> button once. The display reads:
2. Press the <4> button and then turn the <Data> wheel to select the CC send for the expression pedal.
CC Transmit Channel - This option allows you to set the MIDI channel on which CCs will be sent out the RP-20 Valve MIDI Out port to
other MIDI devices. If you are using the RP-20 Valve only, you don't need to worry about setting up this option.
However, if you plan to use the RP-20 Valve for continuous control over other MIDI devices (either in conjunction with the RP-20 Valve or by
themselves), you need to assign a MIDI transmit channel for each of the CC numbers you'll be using for continuous control of the other
devices.
To change the MIDI channels on which the selected CCs will transmit to other MIDI devices, do the following:
1. Press the <Utility> button once, then turn the <Data> wheel until you reach page 10 of the utility menu. The display will appear
something like this:
2. Now press either <2> and then turn the <Data> wheel to select the bank, <3> and then turn the <Data>wheel to select the
footswitch and press the <4> button and the turn the <Data> wheel to set the CC transmit number. To exit, press the <Program>
button.
To Next Page
Loading...
