Noise Gate
The Silencer noise reduction system is definitely going to become your best friend in any recording session or live performance for keeping
signals quiet.
Noise Gate Parameters
Type Selects the type and placement of the noise reduction to be used.
Threshold Set the minimum input level at which the compressor will engage. Ranges from -90 to 0.
Attenuation Adjusts how far the signal is lowered when the gate is closed. Ranges from 1 to 5.
Attack Controls how quickly the gate opens after the signal level reaches Thresh. Range: 1 to 10.
Release Determines how quickly the the gate closes after the signal falls below the Threshold. Ranges from: 1 to 10.
Compressor
Compressor Parameters
Level Controls the signal input level fed to the module. Ranges from Off to 100%.
Threshold Sets the threshold level of the compressor. Ranges from -27 to 0.
Ratio This parameter sets the compressor ratio. Ranges from 1.5 to 40.
Gain This parameter controls the amount of gain in the compressor. Ranges from 0 to 200%.
Attack This parameter controls the attack time of the compressor. Settings are: Slo, Med and Fast.
Release This parameter sets the release of the compressor. Settings are: Slo, Med and Fast.
Delay This parameter sets the delay time of the compressor. Ranges from 0 to 10 ms.
RP-20 Valve
User Guide
Section - 4 Editing Modules
31
To Next Page
Loading...
