Selecting Effect Configuration Routes
Within every Program of the RP-20 Valve, you have the option of selecting any 1 of the 15 Effect Configuration routes available in the RP-20
Valve. This can be very helpful when you have a program that uses a preamp tone that you prefer, but the currently selected effect configura-
tion is not ideal for the digital effects that you wish to use in the Program. You can easily change these Effect configurations by using the
following procedure as a guide:
1. Accessing the effect configurations can be done by pressing the <Effects> button until the display appears like this:
Note that the effect configuration is flashing
2. Now press the <1> button and then turn the <Data> wheel to select any one of the 15 different configurations available.
3. Once the configuration has been selected, press the <Store> button to save any changes.
4. To Exit the configuration menu, just press the <Program> button to return to program mode.
A Complete listing of the effect configurations of the RP-20 Valve can be found on page 76.
FX Edit Mode
1. From Program mode, press the <Effects> button. The display looks something like this:
2. Successive presses of the <Effects> button will move you through the chain of effects modules.
When you enter FX Edit mode, the first page of every FX Module allows you to:
1) Bypass that effect module (by turning it on or off) by pressing the <1> button and then turning the <Data> wheel.
2) Select an Effect Module (Only in the Digital Effect section), by pressing the <2> button and then turning the <Data> wheel.
3) Store the Default by pressing the <3> button and then pressing the <Store> button (for more info on storing Defaults, see pg. 25.
4) Select a Default for the selected Effect Module by pressing the <4> button and then turning the <Data> wheel.
To Next Page
Loading...
