DigiTech RP-20 VALVE - RESET PROGRAM (20 H); RESET DEVICE (21 H); RESET FACTORY SETTINGS (22 H); REQUEST USER DEFAULTS (13 H)

RESET PROGRAM (20h)
SYS_HEAD, 20(h), F7(h)
The Reset Program procedure causes the RP-20 Valve to reload the current saved program.
RESET DEVICE (21h)
SYS_HEAD, 21(h), F7(h)
The Reset Device procedure causes the RP-20 Valve to reboot the software as if the power had been turned off, and then back on. If edits have
been made to the current program without saving, they will be lost.
RESET FACTORY SETTINGS (22h)
SYS_HEAD, 22(h), F7(h)
The Reset Factory Settings procedure causes the RP-20 Valve to reload a sections of the EPROM factory defaults and perform a hard reset.
REQUEST USER DEFAULTS (13h)
SYS_HEAD, 13(h), yy1, yy2, zz1, zz2 F7(h)
When a Request User Default procedure is received, the RP-20 Valve will respond with a Receive User Defaults procedure.
yy= effect ID #
zz= index map max = 5
FX ID # = 255
RECEIVE USER DEFAULTS (14h)
SYS_HEAD,14(h), yy1, yy2, zz1, zz2 F7(h)
The Receive User Defaults procedure is used to receive User Defaults.
yy= effect ID #
zz= index map max = 5
FX ID # = 255
Section - 6 Appendix
RP-20 Valve
User Guide
86