DigiTech RP-20 VALVE - Volume Pedal Assignments

Volume Pedal Assignments
Volume control can be assigned to any program within the RP-20 Valve. When volume control is used in a selected program.
The procedure for assigning volume control to any program of the RP-20 Valve is as follows:
1. From Program mode, you must get to the configuration screen by pressing the <Effects> button until the display reads as follows:
2. Now press the <Next Page> button to page 2 and the display will appear like this:
3. Now press the <1> button and turn the <Data> wheel making the Volume Pedal parameter active for assignment to the Expression
pedal. Now press the <Assign> button and the display will appear like this:
4. Now all you have to do is rock the Expression Pedal to assign the Volume Pedal parameter control, and the display will appear something
like this:
5. Now that the assignment has been made, make sure that you store your changes and press the <Program> button to return to Program
mode.
Vol Pd Exp 1 Min[100]Max
2
FACTORY USER
%kHz
msdB
On
1
CHANGEDLINK
 Pdl
2
CHANGEDLINK
Off
3
CHANGEDLINK
100
4
PAGE
1
OF 19
COMP WAH TUBE EQ
L/R OUTS
L/R OUTS
#
b
GATE
BANK
EQDIST
Select a Contrl F.Switch
2
FACTORY USER
CHANGEDLINK CHANGEDLINK CHANGEDLINK
COMP WAH TUBE EQ
L/R OUTS
L/R OUTS
#
b
GATE
EQDIST
Vol Pdl Morph Pdl
2
FACTORY USER
%
100
1
CHANGEDLINK CHANGEDLINK
%
0
3
CHANGEDLINK
PAGE
2
OF 2
COMP WAH TUBE EQ
L/R OUTS
L/R OUTS
#
b
GATE
BANK
EQDIST
Config: Series 4,4,4,4
2
FACTORY USER
%kHz
msdB
13
1
CHANGEDLINK

CHANGEDLINK CHANGEDLINK
PAGE
1
OF 2
COMP WAH TUBE EQ
L/R OUTS
L/R OUTS
#
b
GATE
BANK
EQDIST
Section - 5 Advanced Topics
RP-20 Valve
User Guide
56