4. Now move the expression pedal to assign the pedal and the display will appear like this:
5. By pressing the <3> button, this will activate the Morph pedal parameter making it ready for assignment. Now press the <Assign>
button and the display will appear something like this:
6. Now select the Expression pedal, and the display will appear something like this:
7. In this example, the expression pedal is now assigned to morph between Solid State and Tube distortion modules. Note that -99 as the
minimum value represents the Solid State (bottom) Amp and the Maximum being 99, represents the Tube (top) distortion. To return to
Program mode, press the <Program> button. Always remember to save any changes.
Morphing Between Effect Modules
Not only does the RP-20 Value allow you to morph between Distortion types, but it also gives you the ability to morph between effect
modules. This can be done when using Effect Configurations 6, 12 or 15 which are split configurations.
The procedure for assigning the morph pedal to the Effect modules uses the same steps as 3 through 7 of the distortion of morphing
assignment procedure.
To Next Page
Loading...
