111
3-2-5 UPnP Setting
This function enables network auto-configuration for peer-to-peer
communications, with this function, network devices will be able to
communicate with other devices directly, and learn about information about
other devices. Many network device and applications rely on UPnP function
nowadays.
Please click ‘NAT’ menu on the left of web management interface, then click
‘UPnP’, and the following message will be displayed on your web browser:
There is only one option in this page, please select ‘Enable’ or ‘Disable’ to
enable or disable UPnP function, then click ‘Apply’ button, and the following
message will be displayed on your web browser:
Please click ‘Continue’ to back to previous setup menu; to continue on other
setup procedures, or click ‘Apply’ to reboot the router so the settings will take
effect (Please wait for about 30 seconds while router is rebooting).
If you want to reset all settings in this page back to previously-saved value,
please click ‘Cancel’ button.
To Next Page
Loading...
