114
3-3-1 Access Control
This function allows or denies computers with specific MAC address from
connecting to the network; it can also allow or deny computers with specific IP
address, protocol, or port.
Please click ‘Firewall’ menu on the left of web management interface, then
click ‘Access Control’, and the following message will be displayed on your
web browser:
Here are descriptions of every setup items:
Enable MAC Check this box to enable MAC address based
Filtering (1): filtering, and please select ‘Deny’ or ‘Allow’ to decide the
behavior of MAC filtering table. If you select deny, all
MAC addresses listed in filtering table will be denied
from connecting to the network; if you select allow, only
MAC addresses listed in filtering table will be able to
connect to the network, and rejecting all other network
devices.
Client PC Please input the MAC address of computer
MAC address (2): or network device here, dash ( - ) or colon ( : ) are not
required. (i.e. If the MAC address label of your wireless
device indicates ‘aa-bb-cc-dd-ee-ff’ or
‘aa:bb:cc:dd:ee:ff’, just input ‘aabbccddeeff’
1
2 3
5 6
7
8
9 10
12
To Next Page
Loading...
Need help?
General
