48
connection when the network traffic is not sending or
receiving after an idle time.
Manual – After you have selected this option, you will see
the “Connect” button and “Disconnect” button, click
“’Connect” and the router will connect to the ISP. If you
want to stop the connection, please click “Disconnect”
button.
Idle Time Out (6): If you have selected the connection type to
“Connect-On-Demand”, please input the idle time out.
After you finish with all settings, please click ‘Apply’ (7) button and the following
message will be displayed on your web browser:
Please click ‘Continue’ to back to previous setup menu; to continue on other
setup procedures, or click ‘Apply’ to reboot the router so the settings will take
effect (Please wait for about 30 seconds while router is rebooting).
If you want to reset all settings in this page back to previously-saved value,
please click ‘Cancel’ button.
To Next Page
Loading...
Need help?
General
